These table units incorporate the head of the 2010 or 2010T bench top systems with a steel top machine stand. The manual, lever arm unit is ideal for single point or small, multi-point assembly operations. The machine head slides left or right on the gantry and can also be adjusted up or down. The spacious machine stand can accommodate large parts needing extended support. If a fixture is desired, it can be made of aluminum with a plastic pad, or roller ball bearings, to allow free movement for part location. Optional safety rails can be added to safeguard heavy fixtures from falling off the table. The table unit was originally designed as a repair station due to the variety it provides.

 

Features:

- Adjustable, locking depth stop for accurate tool adjustment
- Microprocessor based, digital display, temperature
controller with digital set point and proces value readout
- Thermal probe with built-in thermocouple
- 80-999 degree F operating range +/-2 degree accuracy
- Non asbestos insulator
- Easy-access on/off switch

 

Additional Features for the 2010T Table Unit:

- 1-10 second, adjustable assembly timer on 2010T unit
- Cycle complete light
- Magnetic switch that starts timer

- Table Features for either unit:
- Two inch square steel, welded tubing
- Ground steel top
- Large, easy-roll wheels (two rigid and two swivel/locking)
- Two sturdy shelves with 3/4" thick oak plywood
- Symmetrical design allows machine to be used with right or left knee opening

 

Specifications:
Power requirements: 110 VAC, 50/60 Hz
Current draw @ full rated output: 5 amps
Maximum force: 500 lbs.
Stroke length: 2-1/2"
Weight: Approx. 700 lbs

Custom Options (Quoted Upon Request):
Multiple heads for separate tooling setups
Safety rails to keep rolling fixtures contained

 

Part Numbers:

BY114 - 2010T Table Unit