This conversion kit simply turns any 20 kHz ultrasonic welder into a thermal assembly system. The 2005 supplies the heat while your welder controls the timing. The kit consists of a control box with a Watlow temperature controller and a probe assembly, which includes a standard thermal probe, an insulator block and an aluminum adapter block. It also includes adapter studs to attach the thermal probe to your welder. To set up the conversion kit, attach the 2005 thermal probe assembly to any booster that fits the 20 kHz welder you want to adapt. Then, attach that booster to the welder. Set the 2005 temperature controller to the desired temperature, and choose the assembly time by setting the weld and hold timers on your 20 kHz welder. That's all there is to it. You now have a thermal assembly press.

Features:

- Self-contained carrying case with handle
- Microprocessor based, digital display, temperature controller with digital set point and process value readout
- Aluminum adaptor block
- Non-asbestos insulator
- Thermal probe with built-in thermocouple
- 80-999 degree F. operating range +/-2 degree accuracy
- Easy-access on/off switch

Specifications:
Power requirements: 110 VAC, 50/60 Hz
Current draw at full rated output: 2.5 amps
Weight: 6 lbs

Custom Options (Quoted Upon Request):
Additional zones (up to four)
Additional probe assemblies

Part Numbers:

BY025- 2005 Conversion Kit with Probe