ZETZ-9 Compact Themocutter

This Thermocutter features an electrically (110V) heated blade designed for cutting all thermoplastics easily and effortlessly. Heats up instantly. Transformer steps voltage down to a safe level. Cuts through material up to 5 inches thick, depending on density.

The ZETZ-9 Thermocutter is a compact hand-held unit with the transformer built into the handle. Its slim handle makes it convenient for cutting in areas with limited access. The blade heats up quickly and is easily controlled by the spring-loaded ON-OFF switch.

The temperature of the blade can be adjusted to that best suited to your application.Changing blades is easy — just loosen the four screws, insert the blade and tighten. A variety of blades are available
for specific applications. See the following pages for blades and their suggested uses.

CLICK HERE for more info. and pricing

ZETZ-24 Themocutter for Thermoplastics

These hot knife Thermocutters feature an electrically (110V)
heated blade designed for cutting all thermoplastics
easily and effortlessly. Heats up instantly. Transformer
steps voltage down to a safe level. Cuts through material
up to 5 inches thick.
This hot knife Thermocutter is designed for continuous, industrial operation - including on-off batch production, use at a central work station or on-site.

The Zetz-24 can be set for on/off operation or continuous use with the flip of a switch.

The cutting handle is connected to the base unit by a 91/2 foot long 3-line electrical cable. Two lines are for AC power. The on/off switch in the handle electronically actuates the controller in the base unit on the third line using very little power. This 3-line cable design decreases temperature buildup in the handle.

CLICK HERE for more info. and pricing

ZETZ-25 Themocutter with robotic hand

These hot knife Thermocutters feature an electrically (110V)
heated blade designed for cutting all thermoplastics
easily and effortlessly. Heats up instantly. Transformer
steps voltage down to a safe level. Cuts through material
up to 5 inches thick.
This hot knife Thermocutter is designed for continuous, industrial operation - including on-off batch production, use at a central work station or on-site.

The Zetz-24 can be set for on/off operation or continuous use with the flip of a switch.

The cutting handle is connected to the base unit by a 91/2 foot long 3-line electrical cable. Two lines are for AC power. The on/off switch in the handle electronically actuates the controller in the base unit on the third line using very little power. This 3-line cable design decreases temperature buildup in the handle.

CLICK HERE for more info. and pricing